Hanson Rocker’s combine tough 3/16" steel, maximum bottom and side impact protection, and sleek styling. Rocker’s attach easily with 5/16-18 truss head machine screws (provided) into side of tub and up through floor pan on the bottom.

A"Z" form is welded onto the bottom of the main panel for bolting to the floor pan. Panels protrude out 2" from tub and are 5 1/2" high on sides. There’s only about ½” of vertical ground clearance lost.

The ends of all rockers are cut with a compound miter method to match the flare angle. They are capped and ground smooth. Capping prevents the ends from distorting, as this is where the rockers will take a good percentage of hits. Capping the ends is an extra step that is worth the effort to create a much stronger Rocker.

For vehicles with mismatched tubs, front fenders, flairs, or even odd aftermarket flairs, components can be purchased for assembling to the requirement of your combination. The cost of these kits will vary according to the pieces required (approx. $140) Email or fax the combination and a tech will respond. Keep in mind that these items will only be close, so cutting the Rocker Forms to length and maybe trimming the end caps before putting together will be necessary.